2010 Yamaha Yzf R125

Front Nail in tyre ()

Nearside Rear Drive chain slightly loose (6.1.7 (c) (i))

Nearside Rear Drive chain worn but not considered excessive (6.1.7 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front sprocket cover missing

Front Brake excessively binding (1.2.1 (f))

Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Horn not working (7.7 (a))

Nearside Rear Direction indicator likely to become detached (4.4.1 (c) (ii))

Front Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Brake excessively binding (1.2.1 (f))

Rear Footrest missing both sides (6.2.12 (a))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Stop lamp not working front brake control (4.3.1 (a) (ii))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Brake excessively binding (1.2.1 (f))

Front Stop lamp not working (4.3.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Footrest missing (6.2.12 (a))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Offside Throttle control functioning such that safe operation of the motorcycle is adversely affected Revs up on Full R/H Lock (6.2.7 (a) (ii)) DANGEROUS

Clutch lever bent (6.2.7 (b))

Exhaust noisy (8.1.1 (a))

Front Tyre (Rear Fitment Only) Fitted

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Drive chain excessively loose (6.2.1d)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))