2003 Toyota Yaris

Front Brake disc worn, but not excessively both (1.1.14 (a) (i))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Heavy corrosion to both rear axle mounting points (5.3.6 (a) (i))

Headlamp lens slightly defective both faded/misted giving poor patterns (4.1.1 (b) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive very rusty around both rear axle mounting points (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Nearside washer jet not working

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated damaged (6.1.7 (g) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive corroded around both rear axle mountings (5.3.6 (a) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive corroded around both rear axle mountings (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive corroded around both rear axle mountings (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm 175/65/14 (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Items removed from driver's view prior to test

Nearside Front Nail in tyre

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear inner cills corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

handbrake cable mounting brackets corroded and broken.

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both front tyres worn on edges

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both front tyres worn inner edge

near side wiper slightly worn