2004 Ford Fiesta

Central Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust emissions exceed manufacturer's specified limit reading 2.83 limit 2.34 (8.2.2.2 (a))

Front Windscreen washer provides insufficient washer liquid both washers (3.5 (a))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked yellow (6.2.2 (d) (i))

Offside Front Headlamp aim too high adjuster not working (4.1.2 (a))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Exhaust has a major leak of exhaust gases rear box (6.1.2 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Central Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Front Lower Engine mounting damaged but not to excess (6.1.8 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced general underside corrosion (6.1.1 (c) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Front Bonnet primary retaining device ineffective catch broken (3.1 (c))

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill holed and filled with filler (7.1.1 (a) (i))

Nearside Rear Lower Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Lower Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Upper Brake pipe excessively corroded main (1.1.11 (c))

Rear Bumper insecure (6.1.4 (a) (i))

Central Front Lower Engine mounting damaged but not to excess rubber perished (6.1.8 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced all over under body (6.1.1 (c) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Upper Integral body structure is corroded but structural rigidity is not significantly reduced body (6.1.1 (c) (i))

Rear inner arches rusted

Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear inner arches rusted

Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen washer provides insufficient washer liquid (8.2.3)

altrnator drive belt spliting

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

offside rear door trim starting to come off

Offside Headlamp aim too low (1.8)