2005 Kia Sorento

Front Coil spring mounting corroded but not seriously weakened rust on shockers (5.3.1 (b) (i))

Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring mounting corroded but not seriously weakened (5.3.1 (b) (i))

Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rust all over chassis + under sills + floors + under body rust (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive rust on rear shocker mounts (5.3.6 (a) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

rust on rear axle

Central Rear Vehicle structure is fractured but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Central Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material o/s and n/s (1.1.11 (c))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember above fuel tank (6.1.1 (c) (i))

Front Brake pipe corroded, covered in grease or other material o/s and n/s (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive under sill (7.1.1 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced crossmeber by fuel tank (6.1.1 (c) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

rust on chassis +rear crossmember +under sills

Brake pipe corroded, covered in grease or other material front & rear (1.1.11 (c))

rust on chassis +under sills +rear axle

rust on rear cross tube

surface rust on chassis +under sills

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

slight bind on n/s/r brake

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rust on rear axle

rust on rear axle

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)