2005 Ford Transit Connect

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Play in steering rack inner joint(s) ()

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Play in steering rack inner joint(s) ()

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Body insecure inner sill (6.2.2 (a) (i))

Nearside Rear Exhaust has a major leak of exhaust gases front to rear ex (6.1.2 (a))

Offside Front Body insecure inner sill (6.2.2 (a) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar damaged but not seriously weakened (5.3.3 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Central Rear Registration plate lamp likely to become detached light (4.7.1 (c) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar damaged but not seriously weakened (5.3.3 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings rear sill (6.1.B.2)

Offside Body or chassis is damaged, seriously affecting its strength within 30cm of the body mountings rear sill (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Centre Front Lower engine mounting deteriorated resulting in excessive movement (6.1.D.1a)

Centre Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Power steering ram(s) has slight seepage from a component rack (2.3.3b)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing slight dry bearing noise

Offside Track rod end ball joint has slight play (2.2.B.1f)

Rear Direction indicator slightly discoloured both (1.4.A.2f)

Rear Lower outer sills corroded not a prescribed area

battery light on

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)