2007 Chevrolet Lacetti

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Position lamp not working both sides (4.2.1 (a) (ii))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

handbrake has slight reserve travel but has met requirements

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Anti-lock braking system component excessively damaged Pick up ring (1.6 (e))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak ()

front and rear pads low

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Ball joint has excessive play (2.2.B.1f)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Oil leak ()

front and rear pads low

front and rear pads low

front and rear pads low

Oil leak ()

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Oil leak ()

Oil leak

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Oil leak

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Oil leak

Nail in offside rear tyre

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

offside front tyre worn on edges

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nail in offside rear tyre

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

offside front tyre worn on edges

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)