2008 Ford Ka

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Subframe mounting prescribed area excessively corroded significantly reducing structural strength Both rear inner sills marked in yellow chalk next to rear axle mount (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Both rear inner arches marked in yellow chalk (5.3.6 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Inner sill to floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge Both front (5.2.3 (e))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Offside Side repeater not working (4.4.1 (a) (ii))

Hazard warning switch faulty (4.4.2 (a) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

nearside front floor showing signs of corrosion

Front suspension has slight movement at a wishbone pin or bush both (2.5.A.1c)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

drivers door dented

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch area's marked in yellow (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner & outer sill area's (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

nearside front tyre is on the limit outer edge

offside rear tyre is worn unevenly / negative camber from accident damage

Nearside Rear position lamp(s) not working (1.1.A.3b)

Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Windscreen washer provides insufficient washer liquid (8.2.3)