2009 Yamaha Ybr 125 Custom

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Wheel fixing loose (single fixing) (5.2.1 (a) (ii))

Nearside Rear Road spring mounting damaged but not seriously weakened lower mount/bush worn (5.3.1 (b) (i))

Offside Rear Road spring mounting damaged but not seriously weakened lower mount/bush worn (5.3.1 (b) (i))

Dipswitch does not operate immediately when selected on main beam (4.1.3 (b))

Rear Rear reflector missing (4.8.2 (a) (ii))

Stop lamp does not illuminate by the operation of both brake controls front brake light switch inop (4.3.2 (a) (iii)) DANGEROUS

Exhaust slightly loose (6.1.2 (a))

Drive chain slightly tight (6.1.7 (k) (i))

Front Exhaust has a minor leak of exhaust gases blowing from or near the forward header joint (6.1.2 (a))

Nearside Rear Road spring mounting damaged but not seriously weakened lower mount/bush worn (5.3.1 (b) (i))

Offside Rear Road spring mounting damaged but not seriously weakened lower mount/bush worn (5.3.1 (b) (i))

Motorcycle structure corroded to the extent that the rigidity of the assembly is significantly reduced (SWING ARM CORROSION HOLES) (6.1.1 (c) (i))

Nearside Rear Shock absorber has negligible damping effect (SWING ARM BUSHES SEIZED) (5.3.2 (b))

Offside Rear Shock absorber has negligible damping effect (SWING ARM BUSHES SEIZED) (5.3.2 (b))

(EXHAUST FOULING REAR OF SWING ARM)

Offside Exhaust is leaking but is not excessively noisey Exhaust slightly blowing from joint (7.1.1b)

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Nearside Drive chain worn to excess (6.2.1e)

Nearside Front Drive chain sprocket worn to excess Front sprocket (6.2.1e)

Nearside Rear Drive chain excessively loose Chain so loose it is rubbing on the stand (6.2.1d)

Nearside Rear Drive chain sprocket carrier worn to excess Cush drive rubber blocks worn (6.2.1e)

Nearside Rear Drive chain sprocket worn to excess Rear sprocket (6.2.1e)

Brake lever is damaged but the brake can still be readily applied Front brake lever slight bent (3.1.3c)

Front Clutch lever security device missing

Offside Exhaust is leaking but is not excessively noisey Exhaust slightly blowing from joint (7.1.1b)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Drive chain excessively loose (6.2.1d)

Drive chain sprocket carrier worn to excess (6.2.1e)

Drive chain worn to excess (6.2.1e)

Registration plate deteriorated Broken Plate (6.3.1d)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Clutch lever shortened. (Ball Missing) (6.2.1g)

Nearside Front shock absorber has light misting of stanchion (Fork Seal) (2.3.3)

Rear Rear wheel bearings have slight free play (2.4.A.2c)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front suspension assembly slightly corroded. (2.3.1)

Rear wheel bearings have slight free play (2.4.A.2c)

Brake master cylinder slightly corroded (3.2.B1b)

Clutch lever bent (6.2.1g)

Front Tyre worn close to the legal limit (4.1.3(ii))

clocks damaged casings

Exhaust excessively deteriorated (7.1.1a)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Brake master cylinder slightly corroded (3.2.B1b)

Clutch lever bent (6.2.1g)

Front Tyre worn close to the legal limit (4.1.3(ii))

clocks damaged casings

Clutch lever bent (6.2.1g)

Drive chain sprocket carrier worn to excess (6.2.1e)

Drive chain worn to excess (6.2.1e)

Headlamp aim too high (1.6)

Headlamp aim too high and too far to the right. (1.6)

Offside Front Brake pad(s) contaminated by oil or grease (3.2.A1k)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Clutch lever bent (6.2.1g)