2005 Fiat Panda

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Exhaust mounting defective centre (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Exhaust mounting defective centre (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers has a slightly worn bush top bush (5.3.2 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Shock absorbers has a slightly worn bush top mount (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has a slightly worn bush top bush (5.3.2 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Oil leak, but not excessive gearbox (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view stone chips (3.2 (a) (i))

back axle corroded

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn lower arm rear bush (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers has a slightly worn bush top bush (5.3.2 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Shock absorbers has a slightly worn bush top mount (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has a slightly worn bush top bush (5.3.2 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Oil leak, but not excessive gearbox (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view stone chips (3.2 (a) (i))

back axle corroded

Front Tyre worn close to the legal limit both (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Headlamp aim too high (1.8)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear exhaust box outter casing corroded

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear exhaust box outter casing corroded

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake juddering slightly (3.7.A.2b)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Obligatory mirror insecure (8.1.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake juddering slightly (3.7.A.2b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)