2007 Ford Focus

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

n/s/f gearbox oil seal leaking

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

n/s/f gearbox oil seal leaking

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front coil spring corroded (2.4.C.1b)

Front Tyre worn close to the legal limit both (4.1.E.1)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nail in offside rear tyre

Nearside Front front brake fluctuating, but not excessively (3.7.B.3)

Offside Front front brake fluctuating, but not excessively (3.7.B.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

exhaust pipework has surface corrosion to varying degrees worse towards rear

nsf inner drive shaft outer cup damp advise inspection of oil seal

sideskirts fitted not allowing full inspection of perscribed areas

some front suspension componants have surface corrosion

some rear suspension componants have surface corrosion from failed coatings

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

exhaust pipework has surface corrosion to varying degrees worse towards rear

nsf inner drive shaft outer cup damp advise inspection of oil seal

osr and nsr tyers have staple in center of treads

sideskirts fitted not allowing full inspection of perscribed areas

some front suspension componants have surface corrosion

some rear suspension componants have surface corrosion from failed coatings