2007 Ford Focus

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Headlamp not working on dipped beam NO BEAM PATTERN (4.1.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Oil leaking excessively from engine SUMP LEAKING (8.4.1 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm RAN OFF ON INNER EDGE (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm RAN OFF ON INNER EDGE (5.2.3 (e)) DANGEROUS

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

front tyres worn on inner edges

Nearside Rear Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

passenger front door trim insecure

passenger sunvisor insecure

Nearside Front Headlamp aim not tested (1.8.A.1c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

oil low

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Outer Rear Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp not working on dipped beam (1.7.5a)