2009 Ford Ka

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Upper Shock absorbers has an excessively worn bush (5.3.2 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Service brake excessively binding both (1.2.1 (f))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Suspension arm ball joint has slight play both fronts (5.3.4 (a) (i))

Handbrake has little reserve travel

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust rear silencer is corroded

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust silencer is corroded

Offside Rear the bump stop loose

Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Tyres have cuts but not in excess of the requirements deep enough to reach the ply or cords

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)