2010 Kia Rio

Nearside Front Nail in tyre ()

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Vehicle structure is deformed but structural rigidity is not significantly reduced Sill (6.1.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Outer Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Offside Front Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Exhaust system insecure flexi pipe slightly damaged (6.1.2 (a))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Lower Suspension arm ball joint excessively worn in hub (5.3.4 (a) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

NO OIL OR COOLANT PRIOR TO TEST

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Outer Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Offside Front Power steering component has slight seepage from a component (2.1.5 (a))

Power steering close to minimum mark (2.1.5 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge heavily worn, very close to legal limit advise replacing asap (5.2.3 (e))

Nearside Front Lower Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Nearside Front Lower Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3 mm (5.2.3 (e))

Offside outer sill damaged

Exhaust mounting defective (6.1.2 (a))

Nearside Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

damage to o/s lower sidesill

n/s/r tyre low pressure

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear registration plate insecure (6.3.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Horn not working (1.6.2a)