2003 Mercedes-benz Vito

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Coil spring corroded both sides (5.3.1 (b) (i))

underbody corrosion

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Headlamp aim not tested dipped beam not working (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

Front Exhaust has a major leak of exhaust gases down pipe (7.1.2)

Nearside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Stop lamp remains on when the brakes are released (1.2.1e)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear engine mounting deteriorated, but not resulting in excessive movement (6.1.D.1a)

there is surface corrosion allround the car

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Stop lamp not working (1.2.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

surface corrosion n/s outer sill,rear chassis,rear crossmember

Brake load sensing valve linkage defective and function impaired (3.6.E.3)

Nearside Headlamp aim too high (1.8)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

surface corrosion n/s outer sill,rear chassis,rear crossmember

Nearside Front Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

n/s/f tyre damaged

Offside Rear Registration plate lamp not working (1.1.C.1d)