2005 Ford Focus

Central Front Exhaust system insecure (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions - engine idle speed too high inlet pipe vacuum split (8.2.1.2 (e))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Power steering ram modified and steering adversely affected steering rack affecting steering movement (2.1.5 (f) (ii)) DANGEROUS

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened disc scored (1.1.14 (a) (ii))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Coil spring corroded both rear (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

front exhaust bracket broken

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim not tested due to dipped beam (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength trailing arm mount (5.3.6 (a) (i))

Offside Windscreen wiper blade missing (3.4 (b) (ii))

Coil spring corroded both rear (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

front exhaust bracket broken

Front Lower Steering column universal joint has slight wear or play (2.2.2 (c))

Front Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Offside Front Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Nearside Front Headlamp aim not tested (4.1.2 (b))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Lower Steering column universal joint has slight wear or play (2.2.2 (c))

Front Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Offside Front Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Offside Front Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Central Front Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Offside Front Outer Nail in tyre ()

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength end of sill (5.3.6 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Central Front Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Outer Nail in tyre ()

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Wiper blades worn.

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Wiper blade worn out.

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Wiper blades worn.

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Tyre worn close to the legal limit Also worn on inner edge! Advised replace. (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

Rear Wiper blade worn out.

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)