2011 Ford Focus

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pad(s) wearing thin very low (1.1.13 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pad(s) wearing thin very low (1.1.13 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge worn on inner edge and small cuts (5.2.3 (e))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge and small cuts (5.2.3 (e))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge worn on inner edge and small cuts (5.2.3 (e))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge and small cuts (5.2.3 (e))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Brake pipe clips or supports missing, pipe adequately supported front to rear pipes near fuel tank clips are damaged (1.1.11 (d) (i))

Central Rear center exhaust section corroded near rear mounting point but not leaking at time of test

Front Brake pad(s) wearing thin inner pads approaching the end of the wear slot (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm bushes slightly deteriorated both sides of vehicle (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated small pin hole and leaking grease (6.1.7 (g) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords small cut in surface unable to tell how deep due to water and dirt ingress (5.2.3 (d) (i))

Rear Brake pad(s) wearing thin pads appear to be thin but unable to say how thin for certain (1.1.13 (a) (ii))

Rear Exhaust mounting defective tail pipe heavily corroded rear mounting point detached (6.1.2 (a))

Rear Lower Suspension arm corroded but not seriously weakened both sides of vehicle (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened both sides of vehicle (5.3.3 (b) (i))

Exhaust has a major leak of exhaust gases tail pipe corroded and hole near rear mounting point (6.1.2 (a))

Brake pipe clips or supports missing, pipe adequately supported front to rear pipes near fuel tank clips are damaged (1.1.11 (d) (i))

Central Rear center exhaust section corroded near rear mounting point but not leaking at time of test

Front Brake pad(s) wearing thin inner pads approaching the end of the wear slot (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread damaged (0.1 (b))

Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm bushes slightly deteriorated both sides of vehicle (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated small pin hole and leaking grease (6.1.7 (g) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords small cut in surface unable to tell how deep due to water and dirt ingress (5.2.3 (d) (i))

Rear Brake pad(s) wearing thin pads appear to be thin but unable to say how thin for certain (1.1.13 (a) (ii))

Rear Exhaust mounting defective tail pipe heavily corroded rear mounting point detached (6.1.2 (a))

Rear Lower Suspension arm corroded but not seriously weakened both sides of vehicle (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened both sides of vehicle (5.3.3 (b) (i))

Offside Front Nail in tyre ()

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt Split (6.1.7 (g) (ii))

Nearside Rear Shock absorbers has a serious fluid leak Negligible damping effect also (5.3.2 (b))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Nail in tyre ()

Nearside Front suspension arm rear bush deteriorated

Nearside under tray damaged unlikely to fall

Offside Front suspension arm rear bush deteriorated

Nearside Front suspension arm rear bush deteriorated

Nearside Headlamp aim too low (4.1.2 (a))

Nearside under tray damaged unlikely to fall

Offside Front suspension arm rear bush deteriorated

Offside Headlamp aim too low (4.1.2 (a))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Manufactures engine and body covers fitted restricting inspection of components

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Manufactures engine and body covers fitted restricting inspection of components

Engine cover and undertray fitted.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)