2002 Mazda MX-5

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced o/s and n/s also o/s/r sill (6.1.1 (c) (i))

Rear Brake disc worn, but not excessively Pads wearing thin (1.1.14 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced o/s and n/s (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Coil spring corroded (5.3.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Brake pipe excessively corroded Main feed (1.1.11 (c))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced o/s and n/s (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Coil spring corroded (5.3.1 (b) (i))

Brake pedal wearing smooth (1.1.2 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

General corrosion to underbody.

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pedal wearing smooth (1.1.2 (c))

Engine management lamp on.

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

General corrosion to underbody.

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Auxiliary belt worn

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm corroded but not seriously weakened upper and lower (5.3.3 (b) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis leg (6.1.1 (c) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm corroded but not seriously weakened upper and lower (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm corroded but not seriously weakened upper and lower (5.3.3 (b) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis leg (6.1.1 (c) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened upper and lower (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault Intermittently comes on and off during test (1.6 (b))

Engine MIL inoperative or indicates a malfunction Came on during emissions test (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake fluid warning lamp illuminated (1.1.10 (f))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis leg (6.1.1 (c) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Chassis leg (6.1.1 (c) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Suspension arm corroded but not seriously weakened Both sides, front and rear (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake fluid warning lamp illuminated (1.1.10 (f))

Nearside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front brake disc excessively scored (3.5.1h)

Offside Front brake disc excessively scored (3.5.1h)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)