2006 Suzuki GZ125

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Brake lever has inadequate reserve travel (3.1.3b)

Brake locking device missing (3.2.A1e)

Drive chain sprocket carrier worn to excess (6.2.1e)

Drive chain worn to excess (6.2.1e)

Front Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Handlebar mounting clamp bolt loose (2.1.1a)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear Drive chain sprocket worn to excess (6.2.1e)

Front Steering movement slightly 'notchy' (2.2.1b)

Rear Drive chain slightly tight (6.2.1d)

Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Small cut in rear tyre, but not dangerous

Front Steering movement slightly 'notchy' (2.2.1b)

Rear Drive chain slightly tight (6.2.1d)

Small cut in rear tyre, but not dangerous

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Drive chain excessively loose (6.2.1d)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))