2007 Land Rover Range Rover

Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Inner Suspension arm pin or bush worn but not resulting in excessive movement also rear upper (5.3.4 (a) (i))

Offside Rear lamp lens cracked

Oil leak, but not excessive (8.4.1 (a) (i))

Outer sill covers fitted

Rear Upper Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

corrosion underside vehicle - sills, subframes, suspension components

Front Brake hose has slight corrosion to ferrule also rear (1.1.12 (f) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement also rear lower (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Oil leak, but not excessive (8.4.1 (a) (i))

Outer sill covers fitted

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

corrosion underside vehicle - sills, arches, subframes, suspension components, chassis rails

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated slightly weeping grease (6.1.7 (g) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Oil leak, but not excessive drive shaft seal leaking (8.4.1 (a) (i))

Offside Front abs wire not fully secured but not insecure

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear brake pad wear wire not secured to pad

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

corrosion in nearside and offside inner and outer sills

engine light on

nearside and offside outer sill covers fitted

nearside rear and offside rear wheel arches corroded

slight corrosion in all underside steering, suspension and braking components

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated slightly deteriorated (6.1.7 (g) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

nearside and offside inner sills corroded

outer sill covers fitted

slight corrosion in all underside steering, suspension and braking components

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

engine management light illuminated

general underbody corrosion

offside and nearside inner sills corroded

Nearside Front Hydraulic brake calliper leaking (1.1.16 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

engine management light illuminated

general underbody corrosion

offside and nearside inner sills corroded

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

corrosion underside vehicle - rear inner sills, subframe

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear at rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear at rear (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

engine cover fitted obscuring some components

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

engine cover fitted obscuring some components

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake pedal wearing smooth on edge (1.1.2 (c))

Engine bay covers obscuring some components

Items removed from driver's view prior to test ()

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Window excessively tinted but not adversely affecting driver's view (3.2 (b) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Outer sill covers obscuring some prescribed areas

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Sound deadening material not fully secure under bonnet (8.1.1 (b) (i))

Under covers obscuring brake pipes & fuel lines

Nearside Front Lower Suspension arm ball joint excessively worn front arm (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake pedal wearing smooth on edge (1.1.2 (c))

Engine bay covers obscuring some components

Items removed from driver's view prior to test ()

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp aim too high and too far to the right. (4.1.2 (a))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Window excessively tinted but not adversely affecting driver's view (3.2 (b) (i))

Offside Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Outer sill covers obscuring some prescribed areas

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Sound deadening material not fully secure under bonnet (8.1.1 (b) (i))

Under covers obscuring brake pipes & fuel lines

general corrosion on underside

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too low (1.8)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Headlamp aim too low and too far to the left. (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Outer Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

noise on roadtest

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

slight play in rear lower hub bushes

Nearside Rear Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)