2002 Suzuki Swift

Front Cross member corroded

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement N/S/F, O/S/F + N/S/R (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Cross member corroded

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement N/S/F, O/S/F + N/S/R (5.3.4 (a) (i))

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material f to r pipe (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Items removed from driver's view prior to test ()

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material f to r pipe (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Exhaust has a minor leak of exhaust gases front cat hanger slightly corroded (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened slightly worn (3.5.1i)

Offside Front tyre slightly cracked and perished

front brAKE DISCS SLIGHTLY WORN

front underbody undersealed

front bumper mountings slightly corroded

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high and too far to the right. (1.8)

front bumper mountings slightly corroded

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Direction indicator not working (1.4.A.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

nearside rear lamp cracked with water in it

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)