2003 Toyota Yaris

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake pipe corroded, covered in grease or other material N/S & O/S (1.1.11 (c))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (5.3.6 (a) (i))

Both rear brake back plates corroded

Brake hose slightly deteriorated Both rear (1.1.12 (b) (ii))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Coil spring corroded All 4 (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

O/s/f headlamp slightly deteriorated

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear beam axle corroded

Suspension arm corroded but not seriously weakened Both front lower (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Coil spring corroded all 4 (5.3.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Suspension arm corroded but not seriously weakened both front (5.3.3 (b) (i))

both rear brake back plates corroded.

o/s front headlamp deteriorated.

rear suspension beam corroded

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

can not check all items due to locations and covers etc

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Headlamp aim too low (4.1.2 (a))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen washer not working (3.5 (a))

can not check all items due to locations and covers etc

Nearside Rear Valve stem seriously misaligned (5.2.3 (j))

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Macpherson strut has excessive play in the sliding bush or gland (2.5.B.1b)

Offside Front Lower Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too high (1.8)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

advise eml light on

advise front subframe corrosion

advise eml light on

advise front subframe corrosion

Nearside Stop lamp not working (1.2.1b)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

long travel in handbrake

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

long travel in handbrake

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

long travel in handbrake

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Stop lamp not working (1.2.1b)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

long travel in handbrake

Nearside Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

long travel in handbrake

o/s wiper blade split

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Nearside Windscreen wiper blade deteriorated (8.2.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too low (1.8)