2003 MG Zt

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity (4.2.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage damaged but not seriously weakened (5.3.3 (b) (i))

fronnt brake lines corroded

front an rear coil springs corroded

under body corrosion

Driver's view of an obligatory external mirror significantly affected by an obstruction (3.1 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity (4.2.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage damaged but not seriously weakened (5.3.3 (b) (i))

fronnt brake lines corroded

front an rear coil springs corroded

under body corrosion

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing Sidewall (5.2.3 (d) (ii))

Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction (3.1 (a) (ii))

Front Position lamp adversely affected by the operation of another lamp All Earthing with nearside indicator (4.2.3 (c))

Headlamp aim too low Both (4.1.2 (a))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Rear Anti-roll bar linkage ball joint excessively worn Both (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Exhaust has a minor leak of exhaust gases Flexi (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing Sidewall (5.2.3 (d) (ii))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Emissions not tested ex smoke (8.2.2.2 (e))

Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Brake servo defective or ineffective (1.1.10 (a) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake servo defective or ineffective (1.1.10 (a) (i))

Front Direction indicator adversely affected by the operation of another lamp (4.4.3 (b))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Direction indicator slightly affected by the operation of another lamp (4.4.3 (b))

Nearside Front Inner Power steering component has slight seepage from a component (2.1.5 (a))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Direction indicator slightly affected by the operation of another lamp (4.4.3 (b))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nail in nearside front tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear brake disc slightly pitted (3.5.1h)

advise excess handbrake travel

Offside Rear brake disc slightly scored (3.5.1h)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Rear brake disc slightly scored (3.5.1h)