2006 Fiat Doblo

Brake load sensing valve stiff (1.1.17 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion throughout underside of vehicle

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion throughout underside of vehicle

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive outer sill slight corrosion (5.3.6 (a) (i))

vehicle undersealed

Exhaust has a minor leak of exhaust gases Front section at flexi. (6.1.2 (a))

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill @ jacking point (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill@jacking point (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Brake load sensing valve inoperative (3.6.E.3)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

rear brake recording little or no effort (3.7.B.5a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Leaf spring shackle pin excessively loose in its bracket (2.4.B.3a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)