2008 Ford Ka

Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Front Position lamp not working dip beam (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both outer sill corroded (5.3.6 (a) (i))

advise : surface corrosion to under body

advise : under body/suspension surface corrosion

Front Headlamp aim too low both (4.1.2 (a))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear outer sills corroded (5.3.6 (a) (i))

advise : under body/suspension surface corrosion

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

advise : under body surface corrosion

Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor area corroded (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear inner arches corroded (5.3.6 (a) (i))

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

advise : under body surface corrosion

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive lower suspension mountain (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mountain (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive lower suspension mountain area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mountain area (5.3.6 (a) (i))

Steering column deformed to the extent that steering is affected upper steering column cross joint (2.1.3 (c) (ii)) DANGEROUS

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive lower suspension mountain (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mountain (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive lower suspension mountain area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mountain area (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement back bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement back bush (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

both inner and outer cills corroded

corrosion to front floor both sides

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion on sills and inner sills n/s and o/s not holed at time of test

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Centre Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Headlamp aim too low and too far to the left. (1.8)

Nearside Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Front Headlamp aim too low (1.8)