2009 Hyundai I10

BOTH rear shocks corroded

Front Shock absorbers has a slightly worn bush BOTH front top mounts - slight play (5.3.2 (c))

Nearside Rear Brake pipe leaking on an air braking system (1.1.11 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

signs of rear exhaust fouling rear axle

slight noise from o/s/r wheel

Front Tyre worn close to legal limit/worn on edge both fronts (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

chip in front windscreen

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Subframe mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Tyre worn close to legal limit/worn on edge both fronts (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

chip in front windscreen

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower arm mounting point (5.3.6 (a) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated gaiter (5.3.4 (b) (i))

parking brake efficiency only just met legal requirements

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated gaiter (5.3.4 (b) (i))

Rear axle corroded

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear axle corroded

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too high (1.8)