2006 Chevrolet Matiz

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced Both outer sills corroded (7.1.1 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Wheel bearing has slight play both rear wheel bearings (5.1.3 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Sound deadening material insecure rear heat shield (8.1.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Wheel bearing has slight play both rear wheel bearings (5.1.3 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front Exhaust system not adequately supported mounting broken (7.1.1)

Nearside Front Anti-lock braking system component excessively damaged abs ring (3.4.2)

Nearside rear brake binding (3.7.B.1)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)