1998 Toyota MR2

Rear under body corroded

Emissions unable to be completed (8.2.1.2 (d))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Other passenger door likely to open inadvertently or not remain closed bonet (6.2.3 (b) (ii)) DANGEROUS

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear under body corroded

Horn not working (7.7 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Central Front Tyre fouling a part of the vehicle (5.2.3 (f))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Headlamp levelling device inoperative (4.1.5 (a))

Horn not working (7.7 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Exhaust silencer insecure (8.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is inadequately repaired inner sill/arch area (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced x2 holes in floor/inner sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced x2 holes in floor/inner sill (7.1.1 (a) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Floorpan (6.1.1 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Exhaust outlet not correctly supported and fouling bumper, however exhaust system remains secure

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect Misting of oil (5.3.2 (b))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded Inner sill (2.4.A.3)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded Inner sill (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Wheel slightly tight to turn

Nearside Rear Exhaust system dropped, but still secure

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose excessively damaged (3.6.B.4d)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

REAR FLOOR TO SILLS HAVE SOME CORROSION

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Front Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Offside Headlamp aim too high (1.8)

REAR FLOOR TO SILLS HAVE SOME CORROSION

Nail in offside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake balance on limit