2005 Mazda 6

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced front to rear (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear under body corrosion

Vehicle structure is corroded but structural rigidity is not significantly reduced all round (6.1.1 (c) (i))

Nearside Rear Suspension arm likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Rear Exhaust mounting defective exhaust silencer (6.1.2 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced all round (6.1.1 (c) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

both rear suspension arms corroding

child seat fitted to n/s/r

surface corrosion inner sills

surface corrosion inner sills + rear chassis rails

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

drivers wiper split but not smearing

engine and sills covered by plastic trim. both front brake discs corroded and worn. exhaust system corroded. rear suspension bushes perished and worn. various steering and suspension components corroded.