2005 Skoda Octavia

Nearside Front Tyre worn close to legal limit/worn on edge worn on edges (5.2.3 (e))

Nearside Rear outer sill corroded

Nearside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all rear (5.3.3 (b) (i))

brake dust shields corroded

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure inner wall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all rear (5.3.3 (b) (i))

brake dust shields corroded

Rear Brake pipe corroded, covered in grease or other material across rear subframe, swollen under coating (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced rear subframe (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both sills, surface corrosion (6.1.1 (c) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material across rear subframe, swollen under coating (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced rear subframe (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced both sills, surface corrosion (6.1.1 (c) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Wishbone bush (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front minor surface corrosion to brake back plates

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

l/h/r back plate corroded r/h/f back plate missing