2013 Ford Ranger

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Brake hose slightly twisted (1.1.12 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Sill corroded

Play in steering rack inner joint(s) ()

Power steering fluid level below minimum (2.1.5 (b) (i))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

driver seat cushion in poor condition

driver seat cushion in poor condition

Brake pedal anti-slip provision missing (1.1.2 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Brake pedal anti-slip provision missing (1.1.2 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))