2013 Peugeot 208

Exhaust mounting defective (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Suspension component corroded but not seriously weakened axle (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides chassis legs (5.3.6 (a) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both (2.1.3 (g) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement both bushes (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement both bushes (5.3.4 (a) (i))

Front Bumper insecure (6.1.4 (a) (i))

Offside Headlamp insecure (4.1.1 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement both bushes (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement both bushes (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic power steering that is 'fly by wire' has the angle of the steering wheel is inconsistent with the angle of the road wheels (2.6 (b) (i))

Electronic stability control switch not functioning correctly (7.12 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Exhaust system not adequately supported (7.1.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

brake disc in such a condition that it is seriously weakened (3.5.1i)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Headlamp aim too high (1.8)