2003 Toyota Corolla

Manufactures engine and body covers fitted restricting inspection of components

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive inner sill (7.1.1 (a) (i))

Nearside Front inner sill corroded outside prescribed area

Offside Rear brake back plate corroded

Manufactures engine and body covers fitted restricting inspection of components

Suspension component mounting prescribed area is corroded but not considered excessive both side rear (5.3.6 (a) (i))

rear axle beam corroded

Brake performance unable to be tested burst hose (1.2.1 (g))

Offside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Nearside Rear Brake hose damaged and likely to fail (1.1.12 (a)) DANGEROUS

Nearside Rear Brake hose leaking on a hydraulic braking system flexible hose burst on brake test (1.1.12 (c) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Manufactures engine and body covers fitted restricting inspection of components

Sub-frame corroded but not seriously weakened rear axle beam (5.3.3 (b) (i))

Nearside Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Manufactures engine and body covers fitted restricting inspection of components

Sub-frame corroded but not seriously weakened rear axle beam (5.3.3 (b) (i))

Sub-frame corroded but not seriously weakened rear axle beam (5.3.3 (b) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive both side rear lower (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Sub-frame corroded but not seriously weakened rear axle beam (5.3.3 (b) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive both side rear lower (5.3.6 (a) (i))

Coil spring mounting corroded but not seriously weakened both side rear (5.3.1 (b) (i))

Manufactures engine and body covers fitted restricting inspection of components

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Sub-frame corroded but not seriously weakened rear axle beam (5.3.3 (b) (i))

can not fully check all components underneath due underseal/oil sprayed on everything

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge spare wheel fitted (5.2.3 (e))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge spare wheel fitted (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

advise corrosion on near and off side inner sills

advise corrosion on rear axle

advise sill covers

advise corrosion on underside

Nearside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Headlamp aim too high (1.8)

Offside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm slightly distorted (2.4.G.1)

Offside Front Lower Suspension arm slightly distorted (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)