2004 Iveco Daily

Brake pipe excessively corroded front to rear as marked (1.1.11 (c))

Central Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting n/s and o/s (6.2.2 (d) (i))

Exhaust fumes entering cabin no tail pipe fitted to remove fumes from under vehicle (6.1.2 (b) (i))

Front Brakes imbalanced across an axle 36% (1.2.1 (b) (i))

Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting n/s and o/s (6.2.2 (d) (i))

Front Registration plate inscription illegible number 5 excessively deteriorated (0.1 (b))

Fuel tank insecure both retaining straps corroded and broken (6.1.3 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Lower Shock absorbers insecurely attached bracket excessively corroded (5.3.2 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded chassis and inner wing (1.1.21 (e) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Lower Shock absorbers has an excessively worn bush and bolt loose (5.3.2 (c))

Offside Front Lower Shock absorbers insecurely attached 50% of fixings missing (5.3.2 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting n/s and o/s (6.2.2 (d) (i))

Rear Towbar excessively corroded within 30cm of towbar mounting n/s and o/s (6.1.6 (i) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced repair to n/s rear chassis not continually welded (only welded on three sides) (6.1.1 (c) (i))

Brake load sensing valve inoperative and ABS not fitted or inoperative part of load sensing arm missing ( from axle to arm) (1.1.17 (c) (ii)) DANGEROUS

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Advanced corrosion on n/s and o/s chassis and front and rear suspension mounts

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive n/s and o/s chassis and brackets corroded (border line) (5.3.6 (a) (i))

secondary bonnet catch not operating

top latches not working on rear loading doors (border line)

Rear brake pipes corroded

Vehicle corroded

Battery insecure (1.9.1)

Brake fluid warning lamp illuminated (3.6.G.2)

Brake load sensing valve inoperative (3.6.E.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Vehicle corroded

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

vehicle has slight surface corrosion

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Fuel system component insecure (7.2.1)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Unable to visually inspect rear brake pads

rear springshackle bushes slightly worn

rear tyres close to limit and damaged slightly

slight play nearside and offside front bottom ball joint