2007 Yamaha Ybr 125

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

exhaust pipe repaired

headlight operation

Steering headbearing excessively stiff or notchy (2.2.2 (f) (i))

Front Tyre tread not clearly visible sidewall cracking (5.2.3 (e)) DANGEROUS

Rear Tyre has a lump or bulge caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Rear Tyre tread not clearly visible (5.2.3 (e)) DANGEROUS

headlight operation

Drive chain worn but not considered excessive corroded and in poor condition (6.1.7 (c) (i))

Front Brake indicates a slightly grabbing brake (1.2.1 (c))

Front Tyre worn close to the legal limit becoming low and perished (5.2.3 (e))

Rear Drive chain sprocket worn, but not excessively slightly worn due to lack of lubrication and incorrect adjustment (6.1.7 (c) (i))

Drive chain excessively loose loose,corroded and not lubricated (6.1.7 (c) (i))

Front Headlamp aim too high too high and lens in poor condition (4.1.2 (a))

Front Stop lamp not working (4.3.1 (a) (ii))

Rear Wheel alignment incorrect which adversely affects the handling chain adjusters incorrectly adjusted (2.4 (a))

Nearside Front Handlebar grip insecure to handlebar (2.2.1 (d) (ii)) DANGEROUS

Front Brake indicates a slightly grabbing brake (1.2.1 (c))

Front Tyre worn close to the legal limit becoming low and perished (5.2.3 (e))

Rear Drive chain sprocket worn, but not excessively slightly worn due to lack of lubrication and incorrect adjustment (6.1.7 (c) (i))

Nearside Rear Upper Rear suspension bush has slight free play (2.4.A2a(i))

Offside Rear Upper Rear suspension bush has slight free play (2.4.A2a(i))

Nearside Rear suspension bush has slight free play top bush (2.4.A2a(i))

Offside Rear suspension bush has slight free play top bush (2.4.A2a(i))

Drive chain slightly loose (6.2.1d)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Nearside Front suspension assembly slightly corroded. (2.3.1)

nearside footrest rubber missing

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Exhaust slightly deteriorated (7.1.1a)

Wheel alignment slightly misaligned. (2.5.1)

brakes slight binding and wear

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Offside Front Front shock absorber seal failed and leaking oil (2.3.3)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Offside Front Front suspension assembly slightly corroded. (2.3.1)