2008 Suzuki Swift

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Items removed from driver's view prior to test ()

Macpherson strut pin or bush worn but not resulting in excessive movement NSF and OSF (5.3.4 (a) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Outer sill covers fitted unable to check

Suspension component mounting prescribed area is corroded but not considered excessive NSR and OSR (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Coolant level low

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Items removed from driver's view prior to test ()

Macpherson strut pin or bush worn but not resulting in excessive movement NSF and OSF (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Outer sill covers fitted unable to check

Suspension component mounting prescribed area is corroded but not considered excessive NSR and OSR (5.3.6 (a) (i))

Rear EXHAUST DETERIORATED

Front Brake disc significantly and obviously worn BOTH SIDES (1.1.14 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear EXHAUST DETERIORATED

Suspension component mounting prescribed area is corroded but not considered excessive offside and near side rear coil spring mounting areas (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive offside and near side rear coil spring mounting areas (5.3.6 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement rear bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement bush at rear of arm (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)