2009 Suzuki Swift

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Bracket repair from the inside (5.3.6 (a) (i))

Nearside Front Upper Macpherson strut pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Bracket repair from the inside (5.3.6 (a) (i))

Offside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive subframe coroded and chassis (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive subframe coroded and chassis (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material Body to hose. (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened Axle. (5.3.3 (b) (i))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material Body to hose. (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened Axle. (5.3.3 (b) (i))

Offside Front Headlamp aim too low (1.8)