2003 MG ZS

Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc both front (2.5.C.1a)

Subframe mounting prescribed area is excessively corroded both front floor (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

sill covers

Nearside Headlamp aim too low (1.8)

Nearside front brake excessively fluctuating (3.7.B.3)

Offside Headlamp aim too low (1.8)

Offside Stop lamp not working (1.2.1b)

Offside front parking brake recording little or no effort (3.7.B.6a)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

sill covers fitted

Nearside Rear Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front front brake binding (3.7.B.1)

Offside Rear front parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Parking brake lever has no reserve travel (3.1.6b)

Nearside Rear Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Headlamp aim too low (1.8)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Front constant velocity joint gaiter deteriorated (2.5.C.1a)

sill covers fitted

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

n/s/r brake disc starting to deteriorate.

o/s+n/s/r tyres starting to crack+perish.

rear flexible brake hoses metal ends corroding.

Offside Rear Brake cable has restricted free movement (3.5.1k)

Offside Registration plate lamp not working (1.1.5c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

n/s/r brake disc starting to deteriorate.

o/s+n/s/r tyres starting to crack+perish.

rear flexible brake hoses metal ends corroding.

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)