2005 Fiat Doblo

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

all suspension corroded

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake hose has slight corrosion to ferrules x 2 on axle (3.6.B.4e)

tail pipe is deteriorated

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp aim too high (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)