2006 Fiat Panda

Coil spring corroded all 4 springs !!!!!!!!! (5.3.1 (b) (i))

Front Exhaust mounting defective but still secure (6.1.2 (a))

Nearside Front Inner Steering component mounting prescribed area is corroded but not considered excessive wing (2.1.2 (e) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust coroded various places

rear axle coroded and repaired

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

nsf inner wing coroded

rear axle coroded and have been welded

Exhaust system insecure clamp missing just after flexy pipe (6.1.2 (a))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Offside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Offside Rear Brake cable insecure (1.1.15 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

nsf inner wing coroded

rear axle coroded and have been welded

Electronic power steering warning lamp indicates a system malfunction (2.6 (a))

Front Exhaust system insecure clamp missing (6.1.2 (a))

Offside Rear Brake cable insecure (1.1.15 (c))

Offside Rear Coil spring mounting corroded and seriously weakened axle (5.3.1 (b) (i))

Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Inner wheel arch is rusty

Nearside Front shock absorber is rusty

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

exhaust is rusty

gear box is leaking

rear axle is rusty

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Exhaust box not in good condition

Parking brake lever has little reserve travel (3.1.6b)

advise rear exhaust box outer skin poor condition

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

advise rear exhaust box outer skin poor condition

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Oil leak

Rear exhaust system slightly deteriorated

Front Brake pad(s) wearing thin (3.5.1g)

rear exhaust corroded

Front Brake pad(s) wearing thin (3.5.1g)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

rear exhaust corroded

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Suspension joint nearside lower dust cover split/missing

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Suspension joint nearside lower dust cover split/missing

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)