2008 Mercedes-benz Vito

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount area (5.3.6 (a) (i))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount area (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear diff bush

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Service brake lagging in operation (1.2.1 (d))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount area (5.3.6 (a) (i))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount area (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear diff bush

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component pin or bush slightly worn rear diff front most mounting bush (5.3.4 (a) (i))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Suspension component pin or bush slightly worn rear diff front bush (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear coil spring broken (2.4.C.1a)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Side repeater not working (1.4.A.2c)

Offside Headlamp aim too high (1.8)

Nail in nearside rear tyre

offside front tyre outer side wall split no cords apparent at time of test