2008 Ford Ka

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced all over (6.1.1 (c) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all (6.2.2 (d) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake hose excessively chafed Insecure (1.1.12 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Floor excessively deteriorated In boot (6.2.4 (a) (i))

Rear Inner Floor excessively deteriorated Both inner arch (6.2.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust system corroded

Nearside Rear Body has slight corrosion Sill (6.1.B.2)

Oil leak ()

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Headlamp aim too low Fault with adjuster (1.8)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front coil spring broken (2.4.C.1a)

Offside Inner Seat belt anchorage prescribed area is excessively corroded Centre (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Exhaust system corroded

Nearside Rear Body has slight corrosion Sill (6.1.B.2)

Oil leak ()

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Brake hose twisted (3.6.B.4c)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings chassis leg by exhaust mount (6.1.B.2)

Rear Brake cable insecure both sides (3.5.1d)

Rear Suspension component mounting prescribed area is excessively corroded both side inner sills (2.4.A.3)

Rear exhaust bracket broken

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too high and too far to the right. (1.8)

corrosion on both rear sills

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

corrosion on both rear sills