2012 Ford Mondeo

Central Lower Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Lower Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Nearside Rear Suspension arm pin or bush excessively worn Trailing arm bush (5.3.4 (a) (i))

Nearside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Outer Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Inner Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords Outer side wall (5.2.3 (d) (i))

Offside Rear Suspension arm pin or bush excessively worn trailing arm (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front wheel alignment check strongly advised due to uneven front tyre wear

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

All tyre pressures prior to MOT were very low

Front wheel alignment check strongly advised due to uneven front tyre wear

Nearside Rear tyre pressure was at 6psi prior to MOT test

Engine covers fitted obscuring some components in the engine bay

Items removed from driver's view prior to test

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Engine covers fitted obscuring some components in the engine bay

Items removed from driver's view prior to test

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components