2014 Nissan Navara

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Headlamp cleaning device inoperative (4.1.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Steering column top bearing slightly worn (2.2.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Windscreen washer not working (3.5 (a))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Steering column top bearing slightly worn (2.2.2 (b))

Offside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear fog lamp does not emit a steady red light (4.5.4 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Suspension component ball joint has slight play generic lift in swivel joints (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Suspension component ball joint has slight play generic lift in swivel joints (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))