2001 Toyota Yaris

engine light illuminated

rear axle corroded

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

engine light illuminated

rear axle corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Exhaust system insecure (6.1.2 (a))

Headlamp has a product on the light source so that the light output is severely reduced x2 (4.1.4 (b))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases back box joint (6.1.2 (a))

Exhaust mounting defective front pipe (6.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. to high (1.4.2 (a) (i))

corrosion on front and rear suspension components

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

hand brake lever needs ajustment slight to high

slight corrosion on rear suspension components

slight exhaust blow on the back box joint

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

hand brake lever needs ajustment slight to high

slight corrosion on rear suspension components

slight exhaust blow on the back box joint

engine light on at time of test

slight corrosion to front and rear suspension components

Nearside Rear Stop lamp not working (1.2.1b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

engine light on at time of test

slight corrosion to front and rear suspension components

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust corroded

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

exhaust corroded

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Front registration plate letter/figure incomplete (6.3.1c)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

front brake discs worn more than 50%

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Outer Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)