2002 Peugeot 206

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Headlamp lens slightly defective both misting over (4.1.1 (b) (i))

Front Items removed from driver's view prior to test ()

Front Road wheel slightly distorted both (5.2.2 (c) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive chassis feet both sides (5.3.6 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Play in steering rack inner joint(s) ()

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive both sills (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides chassis (5.3.6 (a) (i))

Central Front slight corrosion to front lower floor but not yet effecting proscribed areas

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Lower Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Brake pipe corroded, covered in grease or other material inner (1.1.11 (c))

Nearside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Offside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Lower Vehicle structure excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Side repeater not working (4.4.1 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Rear Registration plate lamp inoperative in the case of a single lamp or all lamps X2 (4.7.1 (b) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Exhaust system insecure (6.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear tyres perished

Emissions not tested engine sounds harsh (8.2.2.2 (e))

Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear tyres perished

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive floorpan (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive floorpan (2.4.A.3)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive floorpan (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive floorpan (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Front suspension has excessive movement at a wishbone pin or bush lower arm rear bush (2.5.A.1c)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (3.6.A.1)

Rear Brake load sensing valve seized (3.6.E.3)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Front Side repeater slightly discoloured (1.4.A.2f)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Side repeater slightly discoloured (1.4.A.2f)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Under-trays fitted obscuring some underside components

Nearside Rear Exhaust mounting missing (7.1.1b)