2005 Aprilia RS 50

All lights taped over at time of test

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust noisy (7.1.2)

Fork dust seals perished

Front Brake pad(s) close to minimum limit On limits (3.2A1f(ii))

Front shock absorber has light misting of stanchion (2.3.3)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

All lights taped over at time of test

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust noisy (7.1.2)

Fork dust seals perished

Front Brake pad(s) close to minimum limit On limits (3.2A1f(ii))

Front shock absorber has light misting of stanchion (2.3.3)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Roller brake test indicates a sticking brake (3.3.A1a)

Fork dust seals perished

Rear suspension bush has slight free play (2.4.A2a(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Headlamp deteriorated but function not impaired (1.2.3a)

Drive chain excessively tight (6.2.1d)

Headlamp aim headlamp deteriorated and function impaired (1.2.3a)

Rear Footrest missing (6.2.1a)

Rear Roller brake test indicates brake effort rise disproportional to brake lever or pedal effort (3.3.A1c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Throttle operating incorrectly Throttle does not automatically close (6.2.1f)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Fairings insecure and likely to impede the steering (2.1.2e)

Rear Brake caliper(s) securing bolt(s) missing (3.2.A1j)

Rear Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Rear Footrest missing (6.2.1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Roller brake test No brake control achieves an efficiency of 30%. (3.3.A2a)

Throttle operating incorrectly (6.2.1f)

Front Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Motorcycle structure insecure and likely to affect the correct functioning of the steering or braking wireing (6.1.1c)

Rear Brake caliper(s) securing bolt(s) missing (3.2.A1j)

Rear Roller brake test indicates brake effort fall disproportional to brake lever or pedal effort (3.3.A1c)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

An item not tested (Manual)

Rear mono-shock pivot excessively worn (2.4.B.4)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Drive chain slightly tight (6.2.1d)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear shock absorber has a light misting (2.4.A.1c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Rear Tyre worn close to the legal limit (4.1.3(i))

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear Drive chain sprocket worn to excess (6.2.1e)

Riders seat insecure (6.2.1a)

Drive chain slightly loose (6.2.1d)

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Rear Tyre worn close to the legal limit (4.1.3(i))

c-clip missing from offside front footpeg pivot pin

Drive chain worn but not considered excessive (6.2.1e)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear wheel bearings have slight free play (2.4.A.2c)

Front Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Offside Front Direction indicator not working (1.5.1c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear wheel rotation likely to be impeded (6.2.1b)

Drive chain excessively loose (6.2.1d) DANGEROUS

Offside Handlebar mounting clamp bolt missing (2.1.1a) DANGEROUS

Rear Brake fluid reservoir fluid level dangerously low (3.2.B1d) DANGEROUS

Drive chain worn but not considered excessive (6.2.1e)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear wheel bearings have slight free play (2.4.A.2c)

gear linkage bolt loose

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Exhaust mounting deteriorated. (7.1.1.c)

Drive chain excessively loose (6.2.1d)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Horn not working (1.7.3a)

Nearside Direction indicator not working (1.5.1c)

Offside Direction indicator not working (1.5.1c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear suspension bush has excessive free play (2.4.A2a(i))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Exhaust mounting deteriorated. (7.1.1.c)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Centre Rear Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)