2009 Mitsubishi L200 Double Cab

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Tyre worn close to legal limit/worn on edge All Four. (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake performance unable to be tested (1.2.1 (g))

Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Anti-lock braking system component excessively damaged sensor wire (1.6 (e))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material ALL PIPES COVERED IN UNDERSEAL (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

drivers seat base covering loose on one side

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Service brake lagging in operation (1.2.1 (d))

Offside Front Upper Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material ALL PIPES COVERED IN UNDERSEAL (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

drivers seat base covering loose on one side

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Body/ chassis/ suspension corroded

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Body/ chassis/ suspension corroded

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. close to mot failure ( offside low effort ) (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)