2010 Fiat Panda

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm 1.4MM (5.2.3 (e)) DANGEROUS

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front Coil spring corroded Both (5.3.1 (b) (i))

Nearside Front Passenger door handle sticks slightly in open position but door latches as intended

Nearside Front Tyre worn close to legal limit/worn on edge 2.5MM (5.2.3 (e))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Obligatory mirror slightly loose (3.3 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Rear exhaust silencer heavily corroded / delaminated

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Exhaust clamp excessively corroded

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Obligatory mirror slightly loose (3.3 (b) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Axle corroded at ends around sping pans and bottom shock absorber mountings.

Rear Coil spring corroded Nearside rear and offside rear (5.3.1 (b) (i))

Rear Exhaust clamp excessively corroded

Rear Exhaust silencer outer skin corroded excessively but not leaking exhaust gasses

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Inner Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Inner Tyre has ply or cords exposed (4.1.D.1b)

Nearside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)