2013 Hyundai I10

Front Exhaust has a minor leak of exhaust gases Flexi (6.1.2 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Suspension spring mounting repair covered in underseal (5.3.6 (a) (i))

Vehicle covered in underseal under side

Emissions unable to be completed (8.2.2.2 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases Flexi (6.1.2 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Suspension spring mounting repair covered in underseal (5.3.6 (a) (i))

Vehicle covered in underseal under side

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both sides (4.7.1 (b) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear axle corroded

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Lower Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive Gearbox (8.4.1 (a) (i))

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)