2003 Toyota Yaris

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front exhaust bracket broken however exhaust system adequately supported

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front exhaust bracket broken however exhaust system adequately supported

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front exhaust bracket broken however exhaust system adequately supported

Exhaust has a minor leak of exhaust gases rear box joint (7.1.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust front section mounting bracket broken but system still secure

Offside Front suspension has a suspension lower ball joint securing nut not locked (2.5.B.1a)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust front section mounting bracket broken but system still secure

Offside Stop lamp not working (1.2.1b)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

coil spring corroded (2.4.C.1b)

score in screen

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

centre brake light not working

coil spring corroded (2.4.C.1b)

score in screen

Offside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front constant velocity joint is slightly worn (2.5.C.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Front Headlamp aim too low (1.8)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Headlamp aim too high (1.8)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)